2-20
Loading the Media
How to load a media with a width of less than 297mm
1.
Peel off the separator (yellow) from the carrier sheet to expose the adhesive surface. (Do not discard the
separator, as it will be used again when the carrier sheet is returned to its package for storage.)
Carrier sheet
Peel off the separator
Separator (yellow)
2.
Affix the media for cutting to the adhesive surface of the carrier sheet, making sure that the edges of the
media are parallel with those of the carrier sheet.
Carrier sheet
Media
Adhesive surface
•
Do not use media that is smaller than postcard size.
•
When affixing the media, take care not to cause any air bubbles or creases.
Supplement
Effective Cutting Area
1.
The effective cutting area on the carrier sheet is shown in the diagram below. When loading a media that
is smaller than A3 size in the cutting plotter, be sure to affix it within the cutting area (the adhesive surface).
Moreover, make sure that the edges of the media are parallel with the edges of the carrier sheet.
Media
Carrier sheetCutting area (Adhesive surface)
Wider space sideNarrow space side
420mm
297mm
•
The plotter recognizes the width of the carrier sheet as the cutting area. Be sure to load a media that is the
same size as the media setting that was made in the application software
•
Be sure to use the [ORIGIN] in “QUICK MENU” menu to specify the start position of the cutting operation.
Supplement
To Next Page
Loading...
