6-4
6.2
Manual Position Adjust
Method of manual position adjust is described here.
•
Adjustment will be cleared if following is done.
– Set new origin point.
– Set the media again.
– Set rotation or mirror. (Set the rotation or mirror prior to the axis adjustment)
Axis adjustment will convert in accordance with rotation or mirror in this case.
•
When the inclination of the axis is too large when setting the first and second point, the first and third point, the third
and fourth point, or the second and fourth point, "Angle adjustment error, please reset" will be displayed. After setting
the media so as to make the inclination small, please perform adjustment operations.
•
Axis adjustment will be cleared when point 1 and point 2 is set to same point.
Supplement
Operation
1.
Load the media on which the registration mark patterns are printed.
Confirm that the push roller is steadily on the media within the range of media movement.
This adjustment is based on assumption that media is slightly tilted.
Media might fall off if the tilting of the media is too large.
Supplement
2.
Set a cutter plunger or a pen in the tool holder.
3.
Press the [ ] icon.
4.
Press the [ARMS].
5.
Press the [ ] icon.
6.
Press the [MARK SCAN MODE].
To Next Page
Loading...
