GRAPHTEC CE8000 Series - Page 134

6-5
7. Press the [MARK SCAN MODE].
8. Press the [AXIS ALIGNMENT].
9. Press the [NUMBER OF POINTS].
10. Press the number of points you want to use.
Please refer to the following for adjustments when matching the manual position.
•
2 points matching, ["Point 1" settings] ["Point 2" settings] ["Origin point of the axis adjustment" settings]
[Finish]
•
3 points matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Distance between Point 1-2"
settings] ["Distance between Point 1-3" settings] ["Origin point of the axis adjustment" settings] [Finish]
•
4 points matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Point 4" settings] ["Distance
between point 1-2" settings] ["Distance between point 1-3" settings] [Finish]
Supplement
11. Press the [ ] icon.
12. Press the [DURING DETECTION].