6-6
13.
Press the POSITION ( , , , ) key to move it to the adjustment mark position.
Pressing the POSITION and [SLOW] keys at the same time will move the tool carriage slower.
Supplement
14.
Confirm the position of the tool and press the [ENTER] key.
Set adjustment points 2 to 4 in the same way. (The number of adjustment points varies depending on the
[NUMBER OF POINTS] setting.)
When the adjustment point specification is completed, the DISTANCE screen will be displayed.
15.
Press the number or the [ ] icon.
•
Measured distance is displayed in the top line in the DISTANCE input screen. Input value (initially same as
measured value) is displayed under that.
•
If the input value is not changed, it will assume that there is no difference between measured distance and
the distance in the data.
Supplement
16.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
17.
Confirm the setting and press the [OK].
18.
Press the [SET].
If [NUMBER OF POINTS] is set to 3 or more points, the DISTANCE screen for points 1-3 will be displayed.
Repeat steps 15 to 17 to set the settings.
Supplement
To Next Page
Loading...
