15-9
ARMS Error Messages
Error
Displayed
LCD Display Cause Solution
E04001 Tilt to adjust with AXIS ALIGNMENT is too
large.
Reload the media.
E04004 It is over the setting range of the distance
adjust.
Reset to smaller value.
E04005 Could not scan the registration marks. Check the registration scan position.
E04006 Amount of data has exceeded the I/O buffer
size for the segment area registration mark.
Decrease the data.
E04007 Test pattern plotting position is not within the
plotting area for sensor position adjustment.
Move the media toward center and plot the
test pattern.
E04008 Media end was detected while detecting the
registration mark.
Check the media. Check the print position of
the registration mark.
E04009 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
E04010 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
E04011 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
E04012 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
E04013 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
E04014 It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position of
the registration mark.
To Next Page
Loading...
