7-5
7.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
You can set the range between 0.0 mm and 0.9 mm.
Supplement
8.
Confirm the setting and press the [OK].
9.
Press the [END].
10.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
You can set the range between 0.0 mm and 0.9 mm.
Supplement
11.
Confirm the setting and press the [OK].
12.
Press the [ ] icon.
13.
Press the [ ] icon.
It will return to HOME screen.
Setting of the Initial Down Force
The initial down-force setting is effective when tangential mode is selected.
Tangential mode is generally used for the cutting of thick media. With thick film, additional time is required for the
cutter blade to penetrate the media fully, even when the necessary cutting force is applied.
The cutting operation starts before the cutter blade has fully penetrated the media, causing uncut sections to be
left.
When the initial down force is specified, this force is used as the cutting force immediately after the lowering of the
tool when tangential mode is selected, enabling the cutter blade to penetrate the media rapidly. (As an example,
if the cutting force is 25 and the initial down force is 4, for example, the cutting force applied immediately after the
pen is lowered will be 29.) The upper limit for added value is 38.
Operation
1.
Press the [ ] icon.
To Next Page
Loading...
