GRAPHTEC CE8000 Series - Setting Origin Point When HP-GL Is Set

3-9
Setting origin point when HP-GL is set
When using the HP-GL command, the origin point is set to either the lower left of the cutting area or the center.
•
When using the GP-GL command, this setting does not affect the operation.
•
See "Chapter 11 Settings of Controls from Computer" for setting the COMMAND.
Supplement
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [COMMAND].
4. Press the [HP-GL ORIGIN POINT].
5. Press the origin position you want to use.
6. Press the [ ] icon.
It will return to HOME screen.