4-12
When media change mode is ON
The Change Media message appears each time when ending a single cut in Media Change mode.
Choosing to change media will instantly detect the media and proceed to a copy area.
Operation
1.
Plot the data you want to copy once.
Cutting data is stored in the buffer memory.
2.
Press the [ ] icon.
3.
Press the [COPY].
•
Turning MEDIA CHANGE MODE on will display the CHANGE MEDIA message each time after a single cut.
"If the [QUIT COPY] is pressed, copying will be suspended and it will return to the HOME screen.
•
When exchanging media, the media selection will be chosen from what was selected before copying.
•
If there is no data in the buffer memory, "NO DATA FOR COPY IN BUFFER!" will be displayed. Please send
cutting data.
•
If too much data is sent from the buffer memory, "COPY MODE BUFFER FULL!" will be displayed.
•
If the data to be copied is larger than the cutting area, the message "CANNOT COPY CUT AREA TOO
SMALL!" will be displayed. Please widen the cutting area or load a media that can secure a sufficient printing
area.
Supplement
4.
Press the [MEDIA CHANGE MODE] to turn it to [ON].
5.
Press the [NUMBER OF COPIES].
To Next Page
Loading...
