8-8
8.5
Setting the Shortcut Move
When the plotter received coordinate information for moving with the tool up is continuously from a computer
connected, you can set whether to move to each coordinate in turn or move directly to the final coordinate using
the "SHORTCUT MOVE".
There are following 2 settings for "SHORTCUT MOVE".
OFF: If several coordinates are received continuously, it will move to each in order it is received.
ON: If several coordinates are received continuously, it will directly move to the last coordinate received.
Cutting/plotting time can be reduced if it is set to "ON", if the time to move the tool in raised status is wasteful.
This setting will be saved even if the power is shut off.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [CONFIG].
3.
Press the [ ] icon.
4.
Press the [EFFICIENCY].
5.
Press [SHORTCUT MOVE] to turn it to [ON].
To cancel, set it to [OFF].
6.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
