4-4
Setting cutting width (EXPAND)
Set the width of the cutting area.
Default setting is to the internal edge of the push rollers.
It can be set up to 10 mm outside (positive value).
Setting will affect both ends, resulting the total width change will be double the set value.
Do not set the "INITIAL B. ANGLE POSITION" of the tool setting to "Y OUTSIDE" when the setting value is set to more
than 8 mm. The blade might be damaged by moving the carriage outside the media under this condition.
•
If the value is set, it is able to cut over where the push rollers are, but the push rollers passes where it is cut, creating
a chance of bad feeding depending on the media.
•
Set the width of cutting area, and then send the cutting data to the plotter.
Cutting data in the buffer memory will be cleared when cutting area width is changed.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [AREA] key.
3.
Press the [ ] icon.
4.
Press the [EXPAND].
To Next Page
Loading...
