4-3
4.
Press the [AREA].
5.
Press the [TOOL MOVE].
•
Coordinate value displayed here is the distance to the tool carriage from the origin point.
•
Press [DEFAULT] if the cutting area is not to change.
Supplement
6.
Press the POSITION ( , , , ) keys and move the tool carriage to the position to be the lower left of the
cutting AREA.
7.
Press the [ENTER] key once the tool carriage is in correct position.
8.
Press the [TOOL MOVE].
9.
Press the POSITION ( , , , ) keys and move the tool carriage to the upper right position of the cutting
area.
Please set the X and Y cut range for the areas on the upper right and lower left points to at least 10 mm.
An error message will appear for areas that are too small.
You will need to reset the settings for the upper right and lower left points.
Supplement
10.
Press the [ENTER] key once the tool carriage is in correct position.
11.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
