1-11
Mounting the stock shafts
Mounting (CE8000-60)
1.
Set one stopper in the stock shaft. (Keep the stopper screws slightly loose.)
Stock shaft
Stoppers
2.
Put the side with the gear on the left side of the machine (looking from the back) and then slide the stock
shaft into the media stocker.
Slide the media stocker in so that it is bookended by the gear and the fixed stopper.
Make sure the stock shaft touches the roller.
Change the insertion position of the rear stock shaft according to the roll diameter of the media you want to
use.
Gear
Fixed stopper
Roller
To Next Page
Loading...
