GRAPHTEC CE8000 Series - Setting Adjustment between the Tools

7-20
7.8 Setting Adjustment Between the Tools
If there is a misalignment between the tools, you can correct the misalignment by using this function.
If there is a misalignment in the cutting/plotting between Tool 1 (tool attached to the backward of the tool holder)
and Tool 3 (tool attached to the forward of the tool holder), you can correct it by entering the adjustment value.
Set "ASSIGN TOOL" of tool condition 1 to 1 and set "TOOL" to Pen.
Set "ASSIGN TOOL" of tool condition 2 to 3 and set "TOOL" to Cutter.
Supplement
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [GENERAL].
4. Press the [ ] icon.
5. Press the [TOOL OFFSET ADJ.].
6. Press the [DRAW].