GRAPHTEC CE8000 Series - Page 157

7-21
7. Press the POSITION ( , , , ) keys to move the tool carriage and the media to the position where the
test pattern is cut.
Move it inside of a cutting area greater than 50 mm on both the X and Y axes.
Pressing the POSITION and [SLOW] keys at the same time moves the tool carriage slowly.
Supplement
8. Confirm the tool position and press the [ENTER] key.
Using the pen plunger (Tool 1), plot a “+” mark.
Next, using the pen plunger (Tool 3), plot a “+” mark.
When plotting is completed, TOOL OFFSET ADJ. screen is displayed.
9. Using “+” plotted with the pen plunger (Tool 1) as a reference, measure how much the “+” cut by the cutter
plunger (Tool 3) deviates. (For example, in the case shown in the figure, it is deviated in the -X direction / +
Y direction, so enter X = + * mm, Y = - * mm.)
X mm
Y mm
"+" plotted
with the
cutter plunger
(Tool 1)
"+" plotted
with the
cutter plunger
(Tool 3)
10. Press the [CORRECTION VALUE X].
11. Specify the setting value using the [ ] [ ] icon or the [ ] icon.
You can set the range between -3.0 mm and +3.0 mm.
Supplement