GRAPHTEC CE8000 Series - Priority of Cut Condition Selection

11-3
Priority of cut condition selection
Select the priority of the setting created by different method when the tool condition is set.
All the tool condition that is received from the computer will be ignored, and only the setting and change of the
tool condition from the control panel is accepted when “MENU PRIORITY” is selected. This setting set here is
maintained even if the power is turned off.
On the other hand, it will set the most current tool condition either from the control panel or from the software when
“COMMAND PRIORITY” is selected. The values set from the control panel are maintained, and the values set from
the software are erased when the power is turned off.
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [COMMAND].
4. Press the [ ] icon twice.
5. Press the [CUT CONDITION].
6. Press the setting value you want to use.
7. Press the [ ] icon.
It will return to HOME screen.