11-2
11.1
Settings Related to Command Processing
Make settings related to command processing.
Setting the command
There are 2 types of commands, the GP-GL and the HP-GL, that the plotter can use.
Match the setting to the used software, or set it to AUTO.
•
With the AUTO, automatic detection of the command may make mistake depending on the data. It will give error or
malfunction when it has made mistake. In that case, set the command before using.
•
Always send the data when the plotter is in READY status when the AUTO is set.
•
When using data with the AUTO, it will be ready to automatically detect next command 10 seconds after completing
the cutting. Send next data after 10 seconds has passed after previous cutting when sending data with different
command.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [CONFIG].
3.
Press the [COMMAND].
4.
Press the [COMMAND TYPE].
5.
Press the command you want to use.
6.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
