GRAPHTEC CE8000 Series - To Make 3 Cuts with Set Value and ±1 of Set Value

2-48
6. Press the [ENTER] key.
1 cut test pattern is cut.
When the [ENTER] key is pressed, the tool carriage will start moving, so take care not to get injured by the
cutter blade.
CAUTION
7. Check the test cut results.
8. Press the [OK] or [ENTER] key.
9. Press any position outside the option (blue part).
10. Press the [ ] icon.
It will return to HOME screen.
To make 3 cuts with set value and ±1 of set value
Operation
1. Load the actual media you want to cut.
2. Press the [ ] icon.
3. Press the [CUT TEST].
4. If you want to perform a cutting force test, press the [COMPARE FORCE].
If you want to perform an offset test, press the [COMPARE OFFSET].