2-49
5.
Press the POSITION ( , , , ) keys to move the tool carriage to the location you wish to perform the
test cutting.
Pressing the POSITION and [SLOW] keys at the same time will move the tool carriage slower.
Supplement
6.
Press the [ENTER] key.
If you perform [COMPARE FORCE], three cut test patterns will be cut one with the cutting force
increased or decreased by 1 based on the current cutting force.
If you perform [COMPARE OFFSET], three cut test patterns will be cut one with the offset value
increased or decreased by 1 based on the current offset value.
When the [ENTER] key is pressed, the tool carriage will start moving, so take care not to get injured by the
cutter blade.
The cut test pattern has the cut order and cut force or offset increase/decrease value as shown in the figure
below.
+1 0 -1
Cut Order
Supplement
7.
Check the test cut results.
8.
Press the [OK] or [ENTER] key.
9.
Press any position outside the option (blue part).
10.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
