1-13
1.4
Connecting to the Computer
This section describes how to connect the plotter and the computer.
Use either a USB port, wireless LAN or wired LAN* to connect the plotter to a computer.
The driver software must be installed before connection.
* Wired LAN unit is factory-installed option.
When using USB/Wired LAN
Connection
1.
Check that the power switch is turned off (the " " side is pressed down).
2.
Connect the plotter to the computer using the interface cable.
* This section explains in the CE8000-130.
See the "9.1 Setting Interface" for setting the interface.
Supplement
USB cable
Computer
Connection via USB interface
Network (LAN) cable
(commercially available product)
Computer
Connection via network (LAN) interface
To Next Page
Loading...
