2-24
Changing the hold-down force
The CE8000-130 requires the push roller hold-down force to be set based on the media's width and material type
in order to keep the media in place.
Switching
1.
Lower the media set lever and raise the push roller.
2.
Switch the hold-down force of the central push roller to Medium or Low (OFF) using the hold-down force
switching lever at the rear of the push roller.
3.
Raise the hold-down force switching lever to set it to the Medium state, and lower it to set it to Low (OFF).
Lever Lever
Hold-down force: Medium Hold-down force: Low (OFF)
•
The hold-down force of the push rollers at both ends cannot be changed.
•
When switching the hold-down force, be sure to lower the set lever before switching.
•
Set the hold-down force to be Low (OFF) when cutting by pressing the center of ultra-thin film such as car
film.
•
Please change the hold-down force depending on the type of media.
•
When using the push roller with the hold-down force set to Low (OFF), set "Enabling/Disabling the push
roller sensors (Enabling/Disabling the push roller sensors)" to [INSIDE DISABLED]. And then move the push
roller to a position where there is no grit roller.
Supplement
To Next Page
Loading...
