5-17
3.
Press the [ARMS].
4.
Press the [SENSOR OFFSET ADJ.].
5.
Press the [SCAN].
6.
Press the POSITION ( , , , ) keys to move the tool to the scanning start position.
Feed direction of media
Align the tool to this area
7.
Check the position of the tool and press the [ENTER] key.
After scanning the registration marks, plot the registration marks for comparison. When plotting is
completed, it will return to the SENSOR OFFSET ADJ. screen.
Feed direction of media
Distance adjustment value Y
Distance
adjustment
value X
Registration mark
for adjustment
Registration mark
for comparison
8.
Based on the scanned registration mark for adjustment, measure the distance of how much the adjustment
registration mark needs to be moved so both will overlap, and record the value. As an example, in the figure
in step 7, it needs to move in negative directions for both X and Y directions, so both of the adjustment
values will be negative values.
Position of the registration mark is measured at the center of the line.
Supplement
To Next Page
Loading...
