7-14
3.
Press the [ ] icon three times.
4.
Press the tool condition number (1 to 8) you want to set.
5.
Press the [CUT LINE PATTERN].
6.
Press the [TYPE No.].
7.
Display the TYPE No. you want to use using the
[ ]
and [ ] icons.
8.
Press the Type No. you want to use.
9.
Press the [GAP ACTION].
10.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
•
You can set the range between 1 and 38, or “UP”.
•
Value set here will be the cut force for the uncut part of the perforated lines.
Tool will be raised when set to "UP".
•
Normally, input the smaller value than the FORCE for cutting to make it half cutting.
Supplement
To Next Page
Loading...
