7-15
11.
Confirm the setting and press the [OK].
12.
If the "USER" is chosen in step 7, set the [CUT LENGTH] and [GAP LENGTH].
Follow steps 10 to 11 for this operation.
•
If the TYPE No. 0 to 7 is selected in step 7, CUT LENGTH and GAP LENGTH is only displayed, and not
possible to change.
•
Range possible to set for the CUT LENGTH is 0.01 mm to 500.0 mm.
•
Range possible to set for the GAP LENGTH is 0.01 mm to 10.0 mm.
Supplement
13.
Press the [ ] icon.
14.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
