4-10
Copying when setting COORDINATE AXES ROTATION is performed in the following order.
Origin point
First cut
Copy origin point
Fifth copy
First copy
Copy space
Copy
space
Sixth copy
Third copy
Fourth copy
Second copy
Operation
1.
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2.
Press the POSITION ( , , , ) keys and move the tool carriage to the position to copy.
3.
Press the [ ] icon.
4.
Press the [COPY].
•
“NO DATA FOR COPY IN BUFFER!" is displayed if there is no data in the buffer memory.
•
If too much data is sent from the buffer memory, "COPY MODE BUFFER FULL!" will be displayed.
•
If the data to be copied is larger than the cutting area, "CANNOT COPY CUT AREA TOO SMALL!" will be
displayed. Enlarge the cutting area or load a media that can secure a sufficient cutting area.
Supplement
5.
Press [MEDIA CHANGE MODE] to set to [OFF].
6.
Press the [NUMBER OF COPIES].
To Next Page
Loading...
