GRAPHTEC CE8000 Series - Page 118

5-9
4. Press the [ARMS].
5. Press the [SENSOR ADJUSTMENT].
6. Press the [SENSOR ADJUST].
7. Press the [SCAN].
Press the [DEFAULT] to set the sensor level to the initial value.
Supplement
8. Press the POSITION ( , , , ) keys to move the tool to the scanning start position.
Feed direction of media
Align the tool to this area
Scanning start position
9. Confirm the position of the tool and press the [ENTER] key.
The cross will be scanned and the scanning level will be adjusted.
•
If the cross cannot be scanned, an error message will be displayed.
•
Depending on the condition of the media, it may not be possible to scan it properly even after adjustment.
If the detection operation does not complete normally, please See "6.2 Manual Position Adjust".
Supplement
10. Press the [ ] icon.
11. Press the [ ] icon.
It will return to HOME screen.