GRAPHTEC CE8000 Series - Page 171

9-4
6. Press the [ACCESS POINT].
If no connectable access point is found, the following screen will be displayed.
Please check the status of your wireless LAN router.
Supplement
7. Use the [ ] and [ ] icons to display the access point to be used.
If the access point you want to connect is not displayed, press [ ] to return to the previous screen, then press
[ACCESS POINT] again to update the access point.
Supplement
8. Press the access point you want to use.
9. Enter the encryption key for the access point you want to use.
•
Press the [ ] button to switch between uppercase and lowercase letters.
•
By pressing the [123] button, you can switch the character type in the order of alphabets, numbers, symbols
and Hex.
•
If you enter one or more letters, numbers or symbols, you cannot switch to Hex.
•
If you enter one or more characters in Hex, you cannot switch to alphabets, numbers or symbols.
•
When entering in hex, the number of characters must be an even number.
•
Press the [ ] button to show or hide (*) the encryption key string.
•
Encryption key is saved for the last two access points you connected to.
Supplement