12-6
4.
Press the [BARCODE CUT].
•
If the USB memory is not inserted, the following is displayed.
•
When the Rotation is set to ON, the following display is displayed.
•
When the Mirror is set to ON, the following display is displayed.
•
When the Panel Cutting is set to ON, the following display is displayed.
Supplement
5.
Press the POSITION ( , , , ) key to move the tool to the start mark position.
6.
Confirm the tool position and press the [ENTER] key.
The bar code is scanned.
If the start mark is not scanned, the following display is displayed.
Check the print result of start mark and the scanning start position etc.
Supplement
To Next Page
Loading...
