GRAPHTEC CE8000 Series - Page 258

A-11
Menu items Setting item Initial value
CONFIGURATION
(CONFIG)
SENSOR MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
CUT QUALITY STEP PASS 1
OFFSET ANGLE 30
EFFICIENCY MOVING SPEED AUTO
SHORTCUT MOVE ON
EDIT CUT
CONDITION
No.1 MEDIA NAME Condition No. 1
TOOL CB09U
SPEED 30
FORCE 14
ACCELERATION 2
ASSIGN TOOL 1
DISTANCE ADJUST OFF
CUT LINE PATTERN OFF
BLADE CTRL FORCE 4
TANGENTIAL MODE OFF
OVERCUT START 0.000
END 0.000
INITIAL DOWN FORCE 0
No.2 MEDIA NAME Condition No. 2
TOOL PEN
SPEED/FORCE/ACCELERATION 30/12/2
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.3 MEDIA NAME Condition No. 3
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/12/2
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.4 MEDIA NAME Condition No. 4
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/17/1
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.5 MEDIA NAME Condition No. 5
TOOL CB09U
SPEED/FORCE/ACCELERATION 60/17/3 (CE8000-40)
64/17/3 (CE8000-60)
71/17/2 (CE8000-130)
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.6 MEDIA NAME Condition No. 6
TOOL CB09U
SPEED/FORCE/ACCELERATION 10/22/2
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.7 MEDIA NAME Condition No. 7
TOOL CB09U-K60
SPEED/FORCE/ACCELERATION 30/17/2
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
No.8 MEDIA NAME Condition No. 8
TOOL CB15U
SPEED/FORCE/ACCELERATION 5/30/1
From ASSIGN TOOL to INITIAL DOWN FORCE Same as condition 1
* Setting items and initial values may be changed.