2-8
3.
Pull the roll media forward until the leading edge of the roll media completely covers the sensor.
If the length you pull out is too long, adjust the length by winding it up on the roll side.
Push roller
Media sensor
4.
Position the media and the push rollers to correspond with the width of the media.
The push rollers push down on either side of the media. Use the grit roller position guide to make sure the
push rollers are set on top of the grit rollers.
You can adjust the center push roller's hold-down force.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
•
The media must always be positioned over the media sensor.
•
See "2.4 Aligning the Push Rollers" for the position of the push rollers.
Supplement
When feeding long media (2 meters or more)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
Media
15mm 15mm
To Next Page
Loading...
