GRAPHTEC CE8000 Series - Page 41

2-12
5. Position the media and the push rollers to correspond with the width of the media.
When using CE8000-40/60
The push rollers push down on either side of the media. Use the grit roller position guide to make sure the
push rollers are set on top of the grit rollers.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
•
The media must always be positioned over the media sensor.
•
See "2.4 Aligning the Push Rollers" for the position of the push rollers.
Supplement
When using CE8000-130
Use the 3 push rollers to push down the sides and center of the media. Use the grit roller position guide
and make sure the push rollers are on top of the grit rollers.
The central push roller has the push roller’s hold-down force switching function.
•
The media must always be positioned over the media sensor.
•
See "2.4 Aligning the Push Rollers" for the position of the push rollers and information about push roller
hold-down force.
Supplement
Grit roller position guide
Push roller
Grit roller
Push roller
(The center push roller is not on top of the grit
roller.)
(The center push roller is near the edge.)
(The center push roller is on top of the grit roller.)(The center push roller is on top of the grit roller.)
Media sensor