2-14
7.
Release the lock from the media stopper (while pulling to the exterior, slide it forward).
Media stopper
Slide the media stopper
8.
When the set lever is up (and the media is held down by the push rollers) and the media stopper is
unlocked, pull out the roll media and give it slack.
Create the same amount of slack in the media as will be used for the back of the machine.
•
Dirt from the floor may stick to the media when giving it slack, so please be careful.
•
During continuous operation with roll media, do not make a media slack at the rear of the cutting plotter.
Supplement
Give it slack
To Next Page
Loading...
