2-16
3.
Position the media and the push rollers to correspond with the width of the media.
The push rollers push down on either side of the media. Use the grit roller position guide to make sure the
push rollers are set on top of the grit rollers. You can adjust the center push roller's hold-down force.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
•
The media must be at least 125 mm in length.
•
The media must always be positioned over the media sensor. (For the location of media sensor, see "1.2
Nomenclature".)
•
See "2.4 Aligning the Push Rollers" for information about the position of the push rollers.
Supplement
4.
Load the sheet media so that the sheet media's right edge lines up with the guideline on the front side.
Pull the media taut to make sure that there is no slack in the conveyance path, and then raise the media set
lever to lower the push rollers. Set the sheet media so that the paper's edges line up with the guideline on
the front side.
Line up
Guideline
Media set lever
To Next Page
Loading...
