2-18
3.
Position the media and the push rollers to correspond with the width of the media.
Use the 3 push rollers to push down the sides and center of the media. Use the grit roller position guide
and make sure the push rollers are on top of the grit rollers.
•
The media must always be positioned over the media sensor.
•
See "2.4 Aligning the Push Rollers" for the position of the push rollers and information about push roller
hold-down force.
Supplement
Grit roller position guide
Push roller
Grit roller
Push roller
(The center push roller is not on top of the grit
roller.)
(The center push roller is near the edge.)
(The center push roller is on top of the grit roller.)(The center push roller is on top of the grit roller.)
Media sensor
4.
Load the sheet media so that the sheet media's right edge lines up with the guideline on the front side.
Pull the roll media taut to make sure that there is no slack in the conveyance path, and then raise the set
lever to fix the push roller position and the roll paper.
Media set lever
Line up
Guideline
To Next Page
Loading...
