Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IP Routing Policy Configuration
Huawei Technologies Proprietary
7-6
Operation Command
Cancel the next-hop address of the
routing information
undo apply ip next-hop
import the route to isis level-1, level-2 or
level-1-2
apply isis [ level-1 | level-2 |
level-1-2 ]
Remove the function of importing the
route to isis
undo apply isis
Set the local preference of the BGP
routing information
apply local-preference
local-preference
Cancel the local preference of the BGP
routing information
undo apply local-preference
Set the routing cost of the routing
information
apply cost value
Cancel the routing cost of the routing
information
undo apply cost
set the cost type of the routing information apply cost-type [ internal | external ]
remove the setting of the cost type
undo apply cost-type
Set the route origin of the BGP routing
information
apply origin { igp | egp as-number |
incomplete }
Cancel the route origin of the BGP routing
information
undo apply origin
Set the tag domain of the OSPF routing
information
apply tag value
Cancel the tag domain of the OSPF
routing information
undo apply tag
By default, perform no settings.
Please note that if the routing information meets the match conditions specified in the
Route-policy and also notifies the MED value configured with apply cost-type internal
when notifying the IGP route to the EBGP peers, then this value will be regarded as the
MED value of the IGP route. The preference configured with the apply cost-type
internal is lower than that configured with the apply cost command, but higher than
that configured with the default med command.
7.2.4 Importing Routing Information Discovered by Other Routing Protocols
A routing protocol can import the routes discovered by other routing protocols to enrich
its route information. And the Route-policy can be used for route information filtering to
implement the purposeful redistribution. If the destination routing protocol importing the
routes cannot directly reference the route costs of the source routing protocol, you
To Next Page
Loading...
