Huawei Quidway S6500 Series

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IP Routing Policy Configuration
Huawei Technologies Proprietary
7-9
Table 7-7 Configuring to filter the distributed routes
Operation Command
Configure to filter the routes
distributed by the protocol
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ routing-process ]
Cancel the filtering of the routes
distributed by the protocol
undo filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ routing-process ]
By far, the route policy supports importing the routes discovered by the following
protocols into the routing table:
direct: The hop (or host) to which the local interface is directly connected.
static: Static Route Configuration
rip: Route discovered by RIP
ospf: Route discovered by OSPF
ospf-ase: External route discovered by OSPF
ospf-nssa: NSSA route discovered by OSPF
isis: Route discovered by IS-IS
bgp: Route acquired by BGP
If routing-process is BGP, you should also specify the process number or AS number
accordingly.
By default, the filtering of the received and distributed routes will not be performed.
7.3 Displaying and Debugging the Routing Policy
After the above configuration, execute display command in any view to display the
running of the routing policy configuration, and to verify the effect of the configuration.
Table 7-8 Displaying and debugging the route policy
Operation Command
Display the routing policy display route-policy [ route-policy-name ]
Display the path information of the AS
filter in BGP
display ip as-path-acl [ acl-number ]
Display the address prefix list
information
display ip ip-prefix [ ip-prefix-name ]