Huawei Quidway S6500 Series

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IP Routing Policy Configuration
Huawei Technologies Proprietary
7-10
Operation Command
Display the Community-list
information
display ip community-list
[ basic-comm-list-number |
adv-comm-list-number ]
7.4 Typical IP Routing Policy Configuration Example
7.4.1 Configuring to Filter the Received Routing Information
I. Networking requirements
z Switch A communicates with Switch B, running OSPF protocol.
z Import three static routes through enabling the OSPF protocol on the Switch A.
z The route filtering rules can be configured on Switch B to make the received three
static routes partially visible and partially shielded. It means that routes in the
network segments 20.0.0.0 and 40.0.0.0 are visible while those in the network
segment 30.0.0.0 are shielded.
II. Networking diagram
area 0
static 20.0.0.0/8
30.0.0.0/8
40.0.0.0/8
Router ID:1.1.1.1
10.0.0.2/8
Switch A
Switch B
Vlan-interface200
12.0.0.1/8
Router ID:2.2.2.2
Vlan-interface100
10.0.0.1/8 Vlan-interface100
Figure 7-1 Filtering the received routing information
III. Configuration procedure
Configure Switch A:
# Configure the IP address of VLAN interface.
[Switch A] interface vlan-interface 100
[Switch A-Vlan-interface100] ip address 10.0.0.1 255.0.0.0
[Switch A] interface vlan-interface 200
[Switch A-Vlan-interface200] ip address 12.0.0.1 255.0.0.0
# Configure three static routes.
[Switch A] ip route-static 20.0.0.1 255.0.0.0 12.0.0.2