Huawei Quidway S6500 Series User Manual

Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 3
IGMP Snooping Configuration
Huawei Technologies Proprietary
3-6
Table 3-3 Configuring the maximum response time
Operation Command
Configure the maximum response
time
igmp-snooping max-response-time
seconds
Restore the default setting
undo IGMP-snooping max-response-time
By default, the maximum response time is 10 seconds.
3.2.4 Configuring Aging Time of Multicast Group Member
This task is to manually set the aging time of the multicast group member port. If the
switch receives no multicast group report message during the member port aging time,
it will transmit the specific query message to that port and starts a maximum response
timer.
Perform the following configuration in system view.
Table 3-4 Configuring aging time of the multicast member
Operation Command
Configure aging time of the multicast
member
igmp-snooping host-aging-time
seconds
Restore the default setting
undo igmp-snooping host-aging-time
By default, the aging time of the multicast member is 260 seconds.
3.3 Displaying and debugging IGMP Snooping
After the above configuration, execute display command in any view to display the
running of the IGMP Snooping configuration, and to verify the effect of the configuration.
Execute reset command in user view to reset the IGMP Snooping statistic information.
Execute debugging command in user view to debug IGMP Snooping configuration.
Table 3-5 Displaying and debugging IGMP Snooping
Operation Command
Display the information about current IGMP
Snooping configuration
display igmp-snooping
configuration
Display IGMP Snooping statistics of
received and sent messages
display igmp-snooping statistics
Display IP/MAC multicast group information
in the VLAN
display igmp-snooping group
[ vlan vlanid ]

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English