Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 3
IGMP Snooping Configuration
Huawei Technologies Proprietary
3-7
Operation Command
Reset the IGMP Snooping statistic
information
reset igmp-snooping statistics
3.4 IGMP Snooping Configuration Example
I. Networking requirements
To implement IGMP Snooping on the switch, first enable it. The switch is connected
with the router via the router port, and with user PC through the non-router ports.
II. Networking diagram
Internet
Multicast
Switch
Router
Figure 3-4 IGMP Snooping configuration networking
III. Configuration procedure
# Display the status of GMRP.
<Quidway> display gmrp status
# Display the current status of IGMP Snooping when GMRP is disabled.
<Quidway> display igmp-snooping configuration
# Enable IGMP Snooping if it is disabled.
[Quidway] igmp-snooping enable
[Quidway] vlan 10
[Quidway-vlan10] igmp-snooping enable
3.5 IGMP Snooping Troubleshooting
Fault: Multicast function cannot be implemented on the switch.