Huawei Quidway S6500 Series - Page 558

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-13
Table 4-18 Sending the Information to SNMP
Device Configuration Default value
Configuration
description
Enable info-center
By default,
info-center is
enabled.
Other configurations are
valid only if the info-center
is enabled.
Set the information
output direction to
SNMP
- -
Set information
source
-
You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information.
Switch
Configuring SNMP
features
-
See
Chapter 5 SNMP
Configuration
Network
management
workstation
The same as the
SNMP configuration
of the switch
- -
8) Turn on/off the information synchronization switch in Fabric