Operation Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 2 Link Aggregation Configuration
Huawei Technologies Proprietary
2-6
During creating an aggregation group, if it already exists in the system but contains no
member port, it changes to the new type; if it already exists in the system and contains
member ports, then you can only change a dynamic or static LACP aggregation group
to a manual one, or a dynamic LACP aggregation group to a static one. In the former
case, LACP shall be disabled at the member ports automatically, while in the latter case,
LACP shall remain enabled.
2.2.3 Add/Delete Ethernet Port into/from Aggregation Group
You can add/delete ports into/from a manual or static LACP aggregation group, but
member port adding or deleting for a dynamic LACP aggregation group is implemented
by the system.
Perform the following configuration in corresponding view.
Table 2-3 Add/delete Ethernet port into/from aggregation group
Operation Command
Add an Ethernet port into the
aggregation group (Ethernet port view)
port link-aggregation group agg-id
Delete an Ethernet port from the
aggregation port (Ethernet port view)
undo port link-aggregation group
Aggregate Ethernet ports (System view)
link-aggregation interface_name1 to
interface_name2 [ both ]
Note that:
z You cannot enable LACP at the mirrored port, port with static MAC address
configured, port with static ARP configured, port with 802.1x enabled.
z You must delete the aggregation group, instead of the port, if the manual or static
LACP aggregation group contains only one port.
2.2.4 Set/Delete Aggregation Group Descriptor
Perform the following configuration in system view.
Table 2-4 Set/delete aggregation group descriptor
Operation Command
Set aggregation group descriptor
link-aggregation group agg-id
description alname
Delete aggregation group descriptor
undo link-aggregation group agg-id
description
To Next Page
Loading...
Need help?
General
