Operation Manual - PoE
Quidway S6500 Series Ethernet Switches Chapter 1
PoE Configuration
Huawei Technologies Proprietary
1-8
# Set the maximum power to 400 W on the board in slot 3.
By default, the power of each board is full, so the power on the board in slot 5 need no
configuration.
[Quidway] poe max-power 400 slot 3
# Set the maximum power to 806 W on the board in slot 5.
[Quidway] poe max-power 806 slot 5
# Disable PoE on Ethernet3/0/23 and Ethernet3/0/24.
[Quidway-Ethernet3/0/23] undo poe enable
[Quidway-Ethernet3/0/24] undo poe enable
# Set the power supply priority of Ethernet3/0/48 to critical, the PD connected with
Ethernet3/0/48 will be powered in precedence on the premise that other ports' power
supplying is not interrupted.
[Quidway-Ethernet3/0/48] poe priority critical
# Enable PoE-compatibility detection on the PoE board in slot 3.
[Quidway] poe legacy enable slot 3
# Set the maximum PoE power on the Ethernet5/0/15 port to 9000 mW.
[Quidway] interface ethernet5/0/15
[Quidway-Ethernet5/0/15] poe max-power 9000
To Next Page
Loading...
