v 2.0 — March 2023 Altanium Delta5
224 Color Change and Non-Thermal Sensitive Resin Example
24. Touch the green check mark button to confirm that the purging has completed
(Figure 13-18).
25. Make sure that the Use Purge Booster checkbox does not have a check mark (not
enabled) (refer to Figure 13-19).
26. Adjust the hot runners’ temperatures to their operational parameters.
27. When the temperatures are at their parameter settings, touch the green check mark
button.
Figure 13-18 Confirm Purging is Complete
Figure 13-19 Adjust Hot Runner Temperatures to Operational Parameters
To Next Page
Loading...
