7. Verify that the PWR OK LED is lit green steadily. See “MX2020 DC and Power Supply Module LEDs”
on page 117, MX2010 DC Power Supply Module LEDs, or MX2008 DC Power Supply Module LEDs for
information on PSM LED behavior.
8. Repeat Steps 1 through 7 for installing PSMs in slots 0, 1, and 2, where required.
Figure 141: MX2000 DC Power Supply Module Front View (240 V China)
NOTE: Each PSM slot not occupied by a (240 V China) DC PSM must be covered by a
PSM blank panel.
RELATED DOCUMENTATION
Powering Off the DC-Powered MX2000 Router | 660
Replacing an MX2000 DC Power Supply Module (240 V China) | 408
316
To Next Page
Loading...
