Juniper MX2020 - Page 412

NOTE: For the MX2010 and MX2008 Routers, pull down the PDM1/Input1 locking levers
to release the PDM from the chassis, and pull up the PDM0/Input0 locking levers to
release the PDM from the chassis.
11. The PDM is extended slightly away from the chassis. See Figure 187 on page 392 (MX2020),
Figure 188 on page 393 (MX2010), and Figure 189 on page 393 (MX2008)
Figure 187: Removing a DC PDM from an MX2020 Router
g007051
392