Kyocera TASKalfa 6501i - Installing the Printed Document Guard Kit (Option)

2N8/2N7-3
1-2-104
1-2-12 Installing the Printed Document Guard Kit (option)
Printed Document Guard Kit installation requires the following parts:
Supplied parts of Printed Document Guard Kit:
*1: Not used in this model.
*2: One piece is used in this model.
Procedure
1. Press the power key on the operation
panel to off. Make sure that the power
indicator and the memory indicator are
off before turning off the main power
switch. And then unplug the power
cable from the wall outlet.
2. Remove nine screws and then remove
the rear upper cover.
*: To fix a cover, insert the hook at the left
top first by bowing the cover.
Figure 1-2-157
Parts Quantity Part.No.
Printed Document Guard Kit (B) 1 1503P40UN0
Parts Quantity Part.No.
Copy guard PWB 1 -
FFC (short) 2 -
FFC (long)* 2 -
Mount plate B*1 1 -
Screws M3 x 6*2 2 -
Screws
Screws
Screws
Screws
Rear upper
cover
Hook