Kyocera TASKalfa 6501i - Leaving Time; Driving Time; Timing; Target Value

2N8/2N7-4
1-3-177
U464 Setting: [Leaving Time]
1. Change the setting value using the +/- keys or numeric keys.
2. Press the start key. The value is set.
Setting: [Driving Time]
1. Change the setting value using the +/- keys.
2. Press the start key. The value is set.
Setting: [Timing]
1. Change the setting value using the +/- keys.
2. Press the start key. The value is set.
Setting: [Target Value]
1. Select the item.
2. Change the setting value using the +/- keys or numeric keys.
3. Press the start key. The value is set.
Method: [Calib]
1. Select [Execute].
2. Press the start key. Calibration is executed.
* : Duplicates selecting [System Menu] - [Adjustment/Maintenance] - [Calibration].
The same operation as System menu.
Completion
Press the stop key.
* : The screen for selecting a maintenance item No. is displayed.
Item No. Description
Display Description Setting range
Initial
setting
Time(min) Setting the standard time of sleep mode 0 to 480 (min) 60
Display Description Setting range
Initial
setting
Time(sec) Setting the drive standard time 300 to 3000 (s) 300
Display Description Setting range
Initial
setting
Time(sec) Setting the drive standard time of con-
tinuous print
0 to 3600 (s) 0
Display Description
Setting
range
Initial setting
65ppm 80ppm
Thick-
ness(K)
Toner thick layer calibration 0 to 1000
145 145
Gamma(K) Light amount calibration 0 to 500
330 330