2N8/2N7
1-3-87
U147 Setting for toner applying operation
Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying
operation). Defines the action that the toner accumulated on the developer blade is sent back in
the developer unit (done by the vibration motor).
Purpose
The setting can be changed to reduce the toner applying quantity. Performed to change the
occurrence of the control of the vibration motor.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the start key.
2. Select the item to be set.
Setting: [Timing]
1. Change the setting value using the +/- keys or numeric keys.
2. Press the start key. The value is set.
Setting: [Mode]
1. Select the mode.
Initial setting; Mode1
2. Press the start key. The setting is set.
Item No. Description
Display Description
Timing Setting timing to transit to toner applying
Mode Settings for toner applying operation
Upper Limit Upper limit printing ratio of toner applying quantity with each mode
Minimum Toner layer width when cleaning mode is selected
Display Description
Setting
range
Initial setting
65 ppm 80 ppm
Paper Int Setting number of pages to transit to
toner applying (between pages)
0 to 100 65 80
Job End Setting number of pages to transit to
toner applying (job completed)
0 to 100 8 8
Display Description
Mode0 Less consumption of toner than a regular toner applying operation
Mode1 Executes toner applying with the regular amount of toner
To Next Page
