2N8/2N7
1-3-122
U244 Checking the DP switches
Description
Displays the status of the respective switches and sensors in the DP.
Purpose
To check if respective switches and sensors in the DP operate correctly.
Method
1. Press the start key.
2. Turn each switch or sensor on and off manually to check the status.
When the on-status of a switch or sensor is detected, that switch or sensor is displayed in
reverse.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U245 Checking messages
Description
Displays a list of messages on the touch panel of the operation panel.
Purpose
To check the messages to be displayed.
Method
1. Press the start key.
2. Change the message using the cursor up/down keys.
When a message number is entered with the numeric keys and then the start key is pressed,
the message corresponding the specified number is displayed.
3. Change the language using the +/- keys.
Completion
Press the stop key.
* : The screen for selecting a maintenance item No. is displayed.
Item No. Description
Display Description
Feed DP feed sensor (DPFS)
Timing DP timing sensor (DPTS)
CIS Head DP CIS sensor (DPCS)
Set DP original sensor (DPOS)
Longitudinal DP original length switch (DPOLSW)
Lift U-Limit DP lift sensor 1 (DPLS1)
Lift L-Limit DP lift sensor 2 (DPLS2)
Cover Open DP interlock switch (DPILSW)
Open DP open/close switch (DPOCSW)
Eject DP eject sensor (DPES)
Slant DP slant sensor (DPSS)
To Next Page
