2N8/2N7-5
1-3-29
U024 HDD formatting
Description
Initializes the hard disk.
Purpose
To initialize the hard disk when replacing the hard disk after shipping.
Caution
In addition, the following settings are also initialized by initializing the hard disk.
System menu (user login administration, job accounting, address book, one-touch keys and doc-
ument box etc.), shortcuts and panel programs
When fully formatted, the following pre-installed software are removed.
Option language, OCR dictionary software, HyPAS Application (FMU etc.).
Method
1. Press the start key.
2. Select the item.
Method: [Format]
1. Select the item.
2. Press [Execute].
3. Press the start key to initialize the hard disk.
4. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Method: [Composition]
1. Select the item.
* : If the wearing number of the HDD is different, C640 will be displayed.
2. Press the start key.
3. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
* : Software removed must be manually re-installed.
Option language, OCR dictionary software: Install using a USB flash device.
Install HyPAS applications (such as FMU) on the application dialog.
* : If an OCT software does not exist, a warning dialog is displayed and OCR is deactivated.
Item No. Description
Display Description
Format Execution of HDD format
Composition* Change of HDD configuration
Display Description
Full Full format
Data Data format (the application software are retained)
Display Description
Single
1-HDD mode
Multi
2-HDD mode
To Next Page
Loading...
