Kyocera TASKalfa 6501i - Adjusting the Print Start Timing

2N8/2N7
1-3-36
U034 Adjusting the print start timing
Description
Adjusts the leading edge registration or center line.
Purpose
Make the adjustment if there is a regular error between the leading edges of the copy image and
original.
Make the adjustment if there is a regular error between the center lines of the copy image and
original.
Method
1. Press the start key.
2. Select the item to be adjusted.
*: 75 ppm model only.
Item No. Description
Display Description
LSU Out Top Leading edge registration adjustment
LSU Out Left Center line adjustment
Mode Sets the conveying timing verification mode.
Reset Resets the conveying timing verification data.
On Timing Verify the conveying timing (sensor on).
Off Timing Verify the conveying timing (sensor recovery).